Receivers - Repeater

Morbus receiver LoRa - RS485 & RS232 interfaces

    118 x 79 x 43mm
    RS485 & RS232 interfaces Modbus RTU
    Compatible with Modbus PLC
    Can manage up to 32 transmitters
    External power supply (7.5 à 24V)

    Reference: RX MODBUS 500-302

This Enless Wireless LoRa receiver is compatible with PLCs with an RS485 or an RS232 Modbus RTU interface.

The Modbus receiver is used to collect data from our LoRa transmitters (Enless sensors only).

The LoRa Modbus receiver can handle up to 32 transmitters.

The transmitter information is stored in the receiver Modbus table. The PLC can then read the registers of the receiver to retrieve the data. It is also possible to write to the Modbus table of the receiver to re-configure already installed transmitters and add new ones.

The receiver is powered externally (either directly via the PLC power supply or via a power supply unit).

This product is LoRa compatible (not LoRaWAN). It allows you to build a radio private LoRa Enless Wireless mode.

Technical Specifications

___________________________________________________________________________________________________________________

Signal repeater - LoRa

    118 x 79 x 43mm
    Very high output power
    No configuration requested
    No limit of repeated transmitters
    External power supply (7.5 à 24V)
    Reference: RX REPEATER 600-301

Thanks to its high radio power, the LoRa signal repeater enables the signal level of the transmitters to be improved in the event of poor reception, without the need for prior configuration.

This repeater has no limit on the number of transmitters to repeat. It is dedicated for use in LoRa private mode.

It is powered externally (7.5 to 24 VDC).

It is particularly suitable for buildings, subterranean offices or high-profile sites.

Technical Specifications

Lisätiedot ja hinnat: Puh. 09 566 0920 tai -